Owner`s manual

14 www.dimplex.com
Operation
Figure 12
Off Button
On
Button
Battery
Cover
Plastic
Strip
Remote Control
The replace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the replace and can pass
through most obstacles (including
walls). It is supplied with one
of hundreds of independent
frequencies to prevent
interference with other units.
Remote Control Usage
The remote control operates the
replace levels sequentially (from
off): ames only; to ames and
low heat; to ames and high heat.
The level is increased every time
the ON button is pressed on the
remote control and the replace
can be turned off at any point by
pressing the OFF button.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out from
between the remote casing and
battery cover (Figure 12).
Remote Control Initialization/
Reprogramming
If the remote control or remote
control receiver has been
replaced, follow these steps to
initialize the remote control and
receiver:
1. Ensure that power is supplied
through the main service
panel.
2. Turn On/Off Switch to “ I ”
(Figure 11A).
3. Move the 3-Position Switch
to the “ REMOTE ” position
(Figure 11B).
4. Press and hold the Manual
Control Button marked “ I ” for
ve (5) seconds (Figure 11C).
After ve (5) seconds, there is
a 10 second window to press
any button on the remote
control.
5. Press any button on the
remote control within that 10
seconds.