Owner`s manual

13
Operation
Figure 11
C
A
B
The manual controls for the
electric replace are located on
the right end of the unit (Figure
11).
A. On/Off Switch
The On/Off Switch supplies power
to all replace functions. When
the switch is in the “I” position,
the unit is on. When in the “O”
position, the replace is off.
B. 3-Position Switch
The 3-Position Switch changes
the mode the replace operates
in and has three (3) positions:
“MANUAL”; “OFF”; and
“REMOTE”.
When in “REMOTE” mode,
the replace's three levels of
operation are controlled by the
ON and OFF buttons of the
remote control.
In “OFF” mode, power to all
functions is cut off.
In “MANUAL” mode, the
replace's three levels of
operation are controlled by the
Manual Control Buttons.
C. Manual Control Buttons
The Manual Control Buttons
operate the replace levels
sequentially (from off): ames
only; to ames and low heat; to
ames and high heat.
The level is increased every time
the “I” button is pressed, and the
replace can be turned off at any
point by pressing the “O” button.
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset.
The temperature cutoff switch
can be reset by unplugging the
unit, waiting ve (5) minutes and
plugging the unit back in.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).