Owner`s manual

11
Fireplace Installation
Media Tray
Front Glass
Assembly
Figure 8
Figure 7
plates from the wall mounting
slots in the back of the
rebox. (Figure 5)
12. Mount the unit on the wall,
so that the tabs on the wall
bracket have been inserted
into the slots on the back of
the rebox. (Figure 6)
13. Carefully pour and evenly
distribute the supplied glass
rock media in the Media tray
of the rebox (Figure 7).
14. Hang the front glass as-
sembly on the mounts of the
rebox and secure the glass
onto the unit by installing the
retaining screws (Figure 8)
15. Excess electrical cord can be
inserted back into the bottom
of the unit, into the cord
storage area.
Pedestal Installation
Instructions
WARNING: Failure to install
the replace as instructed
below may result in damage
to the equipment and or may
expose the user to the risk of
re, serious injury, illness or
death.
CAUTION: High temperature,
keep electrical cords, drapery,
and other furnishings at least
3 feet (0.9m) from the front of
the heater and away from the
side and rear.
Tools Required
• #2 Phillips screwdriver
1. Carefully lay the replace
down on its front.
!
NOTE: If necessary, lay a
Glass Retaining
Screw