Instructions / Assembly
12 www.dimplex.com
the unit and your work surface, (i.e. cloth, cardboard, thick
plastic) to avoid scratching your work surface.
4. Remove the ten screws around the outside ange of
the end panel. (Figure 6)
5. Remove the eight screws on the end panel. (Figure 7)
6. Gently open the end panel, being careful not to strain
the wires connected to the switches
7. Remove the partially reective glass by sliding it out of
the unit.
8. Remove the media and partially reective glass support
bracket, by removing the two center screws from the
top of the bracket and the two screws from the closed
end of the unit. (Figure 9)
9. Locate the icker motor and icker rod.
10. Locate and disconnect the three motor assembly wires
going to the terminal block. (Figure 8)
11. Remove the two motor mounting screws.
12. Separate the motor from the icker connector and
remove.
13. Slide the icker rod out of the snap-in bushing and
remove.
14. Reassemble in the reverse order as above.
Figure 9
Media Support
Bracket