Instructions / Assembly

8 www.dimplex.com
Fireplace Installation
hanging components are
designed for use with Dimplex
replaces only. Improper use,
or use for purposes other than
intended, may cause damage
or injury.
Wall Hanging Instructions
WARNING: Failure to install
the replace as instructed
below may result in damage
to the equipment and or may
expose the user to the risk of
re, serious injury, illness or
death.
WARNING: The replace
requires the wall hanging
bracket screws to be installed
into a minimum of one wall
studs (Figure 1).
Tools Required
• #2 Phillips screwdriver
• Pencil
• Slot screwdriver
• Bubble level (supplied)
• Drill, and drill bits as required
Approximate time: 30 minutes
for installation
1. Remove the two screws that
secure the hanging bracket
to the back of the rebox.
(Figure 1)
2. Select an appropriate location
Figure 1
to mount the unit on a wall,
above an electrical outlet.
Access to the electrical outlet
must be maintained. Ensure
the installation meets the
national and state/provincial
electrical codes.
!
NOTE: It is recommended
that the bottom of the unit
not be mounted higher than
1020mm (40") from the
Fireplace Installation ground
to maintain an optimized
viewing angle of the ame.
(Figure 2)
CAUTION: Ensure that the
top of the unit is at least
152mm (6") from the ceiling
or any object (i.e. Electrical
receptacles) that may
obstruct or be susceptible the
ow or temperature of air out
of the unit.