Operating Instructions Duo300n Duo400n Duo500n 1.3kW / 0.38kW 9.1kWh 1.95kW / 0.47kW 13.65kWh 2.6kW / 0.54kW 18.
Operating Instructions English IMPORTANT SAFETY INFORMATION WARNING - THE SURFACE OF THIS RADIATOR CAN BE HOT. The surface temperatures of this radiator are within the requirements of EN60335 the European Standard covering the safety requirements of electric heating appliances. If aged or infirm persons, or young children, are likely to be left unsupervised in the vicinity of a radiator precautions should be taken to ensure that prolonged contact with the radiator cannot occur.
Controls DuoHeat has two output modes Comfort (Radiant Heat) and Background (Retained Heat). Each needs to be set to the correct level to provide the optimum level of comfort. Reduce the Background setting to Frost Protection Setting (Blue LED). For DuoHeat to operate correctly, both electricity supplies must be switched on at all times. Reduce the Comfort control to Frost Low Protection Setting (Blue LED).
Wall Mounted Programmers (only applicable if Programmer is fitted to DuoHeat installation) RXPW4 - Pilot Wire, or RXMBS4 - Mains Borne Signalling The programmer has two modes (i) AUTO or (ii) MANUAL (i) In “Auto” mode, the radiator will change between Comfort and Setback modes (as shown in the table below) depending on your seven day programme. To change the programme settings or temporarily over ride the programme, see the appropriate programmer instructions.
