Installation Guide

10 www.dimplex.com
WARNING: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of re, electric shock
or damage to persons.
Light Bulb Replacement
Allow at least 5 minutes for light
bulbs to cool off before touching
bulbs to avoid accidental burning
of skin.
Light bulbs need to be replaced
when you notice a dark section of
the ame or when the clarity and
detail of the log exterior disap-
pears. There are two bulbs under
the log set which generate the
ames and embers.
Tool Requirements - Phillips
screw driver
Helpful Hints: It is a good idea to
replace all light bulbs at one time
if they are close to the end of their
rated life. Group replacement will
reduce the number of times you
need to open the unit to replace
light bulbs.
Upper Light Bulb Requirements
Quantity of 1 clear chandelier or
candelabra bulbs with an E-12
(small) socket base, 7 watt rating.
Upper Bulb Replacement
Open door by pulling the 1.
Maintenance
handle.
Locate the upper bulb brack-2.
et.
Bend light retainer bracket 3.
down.
Locate and remove the light 4.
bulb.
Insert new bulb.5.
Bend light retainer bracket 6.
back into its original position.
Close the door.7.
Lower Light Bulb Requirements
Quantity of 2 clear chandelier or
candelabra bulbs with an E-12
(small) socket base, 60 watt rat-
ing.
Lower Bulb Replacement
Open door by pulling the 1.
handle.
Remove the screw from the 2.
logset located in the center
of the emberbed and remove
the logset from the unit.
Locate and examine the bulbs 3.
to determine which bulb(s)
required replacement.
Locate and remove the light 4.
bulb(s).
Insert new bulb(s).5.
Install the logset into the unit, 6.
pushing rmly against the