Use And Care Manual

10 www.dimplex.com
6. Pull the power cord out through the hole in the rear
cover.
7. Install the new power cord through the hole in the rear
cover by placing the strain relief over the cord, hold the
strain relief with pliers and slide into mounting hole.
8. Connect all of the wiring connections in their original
locations.
9. Reassemble in the reverse order as above.
HEATER ASSEMBLY REPLACEMENT
WARNING: If the stove was operating prior to servic-
ing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Gently place stove on it’s back on a at surface.
2. Remove the heater cover retaining screws located on
the bottom of the stove and lower heater/light assembly
onto the oor.
3. Remove the reector rod and motor assembly by
removing the screws on the front and rear of the heater
cover.
4. Disconnect the heater wiring connections from the
heater noting their original locations.
5. Remove the 4 heater mounting screws and remove the
heater from the unit.
6. Reassemble in the reverse order as above.