Owner`s manual
Compact Stove Installation
!
NOTE: A 15 Amp, 120 Volt circuit is required. A dedicated circuit
is preferred but not essential in all cases. A dedicated circuit will
be required if, after installation, the circuit breaker trips or fuses
blow on a regular basis when the heater is operating. Additional
appliances on the same circuit may exceed the current rating of the
circuit breaker.
WARNING: Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord is
stored or secured to avoid tripping or snagging to reduce the risk of
re,electricshockorinjurytopersons.
Construction and electrical wiring must comply with local building
codesandotherapplicableregulationstoreducetheriskofre,
electricshockandinjurytopersons.
Do not attempt to wire your own new outlets or circuits. To reduce
theriskofre,electricshockorinjurytopersons,alwaysusea
licensed electrician.
1. Make sure the unit’s Main ON/OFF switch is switched OFF (refer to
operating instruction section).
2. Plug the unit into a 15 Amp/120 VAC outlet. If the cord does not
reach, you may use an extension cord rated for a minimum of 1875
Watts.
Operation
A. Main On/Off Switch
The switch has two (2) ON
positions marked with
and
“Manual”. The “Manual”
position is for manual
operation. In this position the
built-in remote control is by-
passed.
The
position is for operating
the unit with the provided
remote control. When in
4
Figure 2