Service Manual Model DLG1058 Part Number 6908400100 IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to service this log grate. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N1R 7G8 1-888-346-7539 www.dimplex.
TABLE OF CONTENTS Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Exploded Parts Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation Figure 2 B Figure 1 C Unlocked 3. A The manual controls for the Log Grate are located in the front right side. (Figure 1) A. On/Off Switch Supplies power to the 2-Position Switch. B. 2-Position Switch The 2-Position Switch toggles the unit between Manual Operation and Remote Operation. • Remote (Front Position): The unit is operated with the remote control. • Manual (Back Position): The unit operates with the flames, logs and ember bed.
Figure 3 - Remote Control Functions A. B. C. D. E. F. G. H. I. J. K. L. M. N. Room Temperature Set Temperature Dimmer Flame Speed Control Sleep Timer Flame & Heat On/Off Temperature Down Temperature Up Dimmer Down Dimmer Up Flame Speed Down Flame Speed Up Sleep Timer Down Sleep Timer Up on a thermostat. Press the H or G buttons to adjust the set temperature. Once the desired set temperature is reached the heater will turn off. The heater will cycle on and off to maintain the desired set temperature.
Exploded Parts Diagram 7 8 9 1 5 4 3 2 6 10 Replacement Parts List 1. Flicker Motor. . . . . . . . . . . . . . . . . . . . . . . . . .2000450100RP 6. Remote Control Receiver & Housing . . . . . . .3000960100RP 2. Heater Assembly (with cutout). . . . . . . . . . . . 2203580100RP 7. Log Set Assembly. . . . . . . . . . . . . . . . . . . DLG1058-LOGRP 3. On/Off Switch . . . . . . . . . . . . . . . . . . . . . . . . .2800070700RP 8. Back Log (with Flame Screen). . . . . . . . . . . .
Wiring Diagram MAIN POWER SWITCH L N THERMAL CUTOUT HEATING ELEMENTS LOG HARNESS CONNECTION M FLICKER MOTOR CONNECTION BLOWER MOTOR 6 www.dimplex.
Power Cord Replacement Tools Required: Philips head screwdriver Needle-nose pliers Flat Head Screwdriver Figure 5 WARNING: If the log grate was operating prior to servicing, allow at least 10 minutes for light bulbs and heating elements to cool off to avoid accidental burning of skin. WARNING: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons. 1. Disconnect and remove all of the logs from the unit and put them in a safe place. 2.
board. ! NOTE: Use a flat head screwdriver to gently pry between the end of the connector and the remote control receiver to release the wires. 7. Re-assemble the remainder of the log grate in reverse order from the instructions above.
better grip and squeeze the mounting tabs simultaneously, then push the switch outward. Alternatively, a flat head screw driver can be used to press the each mounting tab down individually and pushing the switch out, alternating sides until the switch is released from its position. 8. Replace the original switch with the new switch, ensuring the correct orientation. 9. Reconnect the wires according to their original configuration. 10.
Troubleshooting Guide Problem Cause Solution General Circuit breaker trips or fuse blows when unit is turned on Short in unit wiring. Trace wiring in unit. Improper circuit current rating Additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet or install unit on a dedicated 15 amp circuit. Unit turns on or off by itself Remote control has a similar frequency to other remotes in the area. Replace Remote Control.
Problem Cause Solution Heater Heater is not turning Off Improper operation Refer to Operation Section Defective Remote Control Receiver Replace Remote Control Receiver. Initialize to Remote Control. Improper operation Refer to Operation Section Loose wiring Check wiring connections Defective heater assembly Replace heater assembly Build up of dirt/dust in heater assembly Ensure that exterior intake louvers and log grate cavity are free of dirt/dust.
