Owner`s manual

12 www.dimplex.com
Operation
Install two (2) AAA batteries 2.
into the remote control
(included).
Ensure Child Lock is in the 3.
“unlocked” position (Figure 2).
Replace the battery cover.4.
!
NOTE: When the “BAT”
symbol is present on
the remote control it is
recommended to replace the
batteries promptly, to maintain
full functionality of the remote/
Log Grate. The remote control
has a battery backup time of
only several hours.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
Remote Control Initialization/
Reprogramming
Plug cord into 120 Volt wall 1.
outlet.
Ensure the On/Off Switch 2.
(Figure 1A)
(ON) position.
Set the 2-Position Switch 3.
(Figure 1B) to the Remote
position (front position).
Press and hold the 4.
Initialization Button on the unit
(Figure 1C).
While holding the Initialization 5.
Button, press the Flame/
Heat On/Off
button on the
remote control.
Release the Initialization 6.
Button on the unit.
Press the Flame/Heat On/Off 7.
button
to turn the Flame/
Heat function On.
Frequency Interference
If the Log Grate does not respond
properly to the remote control,
the remote operating frequency
may have to be reset. The
remote control can send another
frequency code to the remote
control receiver to eliminate
interference.
Simultaneously press the 1.
“Temperature Down” button
and the “Flame Speed
Figure 2
Batteries
Unlocked
Locked
Child Lock Tab