Installation Sheet
Table Of Contents
12 www.dimplex.com
General Operation
!
NOTE: The distance between the heater and the remote control should be less than 10 feet (3m), and the remote
control must be pointed directly toward the heater.
1. Connect the heater to a 120V power outlet. Set the power switch to the I position to put the heater in standby
mode. The display will show a ashing —— to indicate that the unit is in standby mode.
2. Point the remote control toward the heater and press the On button. The heater starts at the high heat setting
(the display will show P3).
3. Select the desired heat setting by selecting Low, Med (medium), or High setting on the remote control. The
display will show P1, P2, or P3 to indicate the setting.
Low
600W
Medium
1050W
High
1500W
Operation
Timer Function
The heater comes with a programmable timer that will automatically place the heater in standby mode after a
predetermined amount of time in intervals of one hour (1-13 hours). The remote has buttons for 1, 2, 4, and 6 hours.
1. Press the button corresponding to the number of hours to add to the timer.
For example, to add 3 hours press buttons 1hr and 2hr. To add 13 hours, press buttons 1hr, 2hr, 4hr, and 6hr.
2. Press the same button again to remove the corresponding number of hours from the timer.
For example, if the timer is set to 3 hours, pressing 2hr will set the timer to 1 hour.
The number of hours remaining on the timer will be shown on the display. After the set number of hours have
elapsed, the unit will enter standby mode and the display will show a ashing ——.
3. To clear the timer, press the On or Standby button on the remote control.
4. Press standby to put the heater in Standby mode.
!
NOTE: There is a built-in safety feature that will automatically set the heater to go into standby mode after eight
hours of continuous operation, unless the timer is activated.
WARNING: Ensure there is no ammable or combustible material in contact or in proximity of the heater body
or top bafe grill before and during operation of this appliance. Ensure heater (body and top bafe grill) is always
free of any obstructions.