Use And Care Manual

13
Installation
WALL CEILING
6. Set the adjustable angle mounting brackets to the desired angle and
fasten brackets with an adjustable wrench.
For ceiling-mounted installation, the available mounting angles are
restricted to 0° and 30° only.
For wall-mounted installation, the available mounting angles are restricted
to 30° and 45° only.
For the DIR 2200W / 3000W, ceiling mounted installation is prohibited.
7. Hang the heater on the brackets and rmly tighten bolts on the bracket to
compress the two plates together as shown in Figure A.
!
NOTE:
Depending on material
and design of ceiling structural
elements, the heater must be
secured with the correct fasteners.
The weight of the heaters
DIR15A10GR, DIR18A10GR,
DIR22A10GR
is up to 5.3 KG
(11.7 lbs.). The weight of the heater
DIR30A10GR
is 6.8 KG
(15.0 lbs.). The installation
structure and hardware
must be able to hold
5 times the weight of the heater.