Owner’s Manual Model DFI2309 DFI2310 IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations. . . . . . . . . . . . . . . . . 3 IMPORTANT INSTRUCTIONS . . . . . . . . . . . . . . . 4 Fireplace Installation . . . . . . . . . . . . . . . . . . . . . . . 7 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Technical Support. . . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for purchasing an electric fireplace from Dimplex. Please use our convenient online registration page to record your model and serial numbers for future reference at www.dimplex.com/register Model Number Serial Number Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation.
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using this heater. ② This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
IMPORTANT INSTRUCTIONS inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored. ⑭ Do not modify the heater. Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. ⑰ Do not burn wood or other materials in the Fireplace. ⑱ Do not strike the front glass. ⑲ Always use a certified electrician should new circuits or outlets be required.
IMPORTANT INSTRUCTIONS This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Fireplace Installation WARNING: Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons. WARNING: Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Fireplace Installation fireplace that is prone to dampness. 2. Cap the top of the chimney flue to prevent rain from entering. 3. Plan your electric power supply. 4. Install an outlet into the existing fireplace. If an outlet is not installed into the existing fireplace the power cord can also run along the front of the hearth to an outlet near the fireplace. 5. Ensure the insert power is off (see Operation). Plug the insert into the outlet and slide the unit into the existing fireplace. 6.
Operation Figure 1 WARNING: This electric firebox must be properly installed before it is used. Manual Controls A - 3-Position Switch The switch has two On positions marked with “ I ” and “ II ”. The “ I ” position is for manual operation. In this position the built-in remote control is bypassed. The “ II ” position is for operating the unit with the provided remote control. When in “ II ” position the unit is operated with the ON and OFF buttons of the remote control.
Operation safety device to prevent overheating. Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It can be reset by switching the 3-Position Switch (Figure 1A) to Off (“ O ” position) and waiting five minutes before switching the unit back on. CAUTION: If you need to continuously reset the heater, unplug the unit and call your local dealer. Remote Control (Figure 2) The fireplace is supplied with an integrated On/Off remote control.
Operation in these steps needing to be followed again. Battery Replacement To replace the battery: 1. Slide battery cover open on the hand held transmitter 2. Correctly install one 12 Volt (A23) battery in the battery holder. 3. Close the battery cover. Battery must be recycled or disposed of properly. Check with your Local Authority or Retailer for recycling advice in your area.
Maintenance into firebox, some force may be necessary to remove. 3. Disconnect the Log Set LED Wire Harness from the unit (DFI2310 only). 4. Unscrew the bulbs counter clockwise. 5. Insert and install new bulbs. 6. Reconnect the Log Set LED Wire Harness to unit (DFI2310 only). 7. Replace the Log Set into the insert. 8. Replace Log Grate and install screws from step 2. Glass Cleaning The glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc.
Maintenance liquids directly onto any surface. Fireplace Surface Cleaning Use warm water only to clean painted surfaces of the Compact Fireplace. Do not use abrasive cleaners. Servicing Except for light bulb replacement and cleaning described above, an authorized service representative should perform any other servicing.
Warranty The limited 12 month warranty period also applies to any implied warranties that may exist under applicable law. Some jurisdictions do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to the purchaser. What this limited warranty does not cover This limited warranty does not apply to products that have been repaired (except by Dimplex or its authorized service representatives) or otherwise altered.
Warranty FORESEEABLE. IN NO EVENT WILL DIMPLEX, OR ITS OFFICERS, DIRECTORS, OR AGENTS BE LIABLE FOR ANY DIRECT LOSSES, COSTS, OR DAMAGES THAT EXCEED THE PURCHASE PRICE OF THE PRODUCT. SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO THE PURCHASER.
Technical Support Technical and troubleshooting support, as well as a list of replacement parts can be found on www.dimplex.com/customer_support. Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N3H 4W3 © 2013 Dimplex North America Limited 16 www.dimplex.
