INSTRUCTION MANUAL 50cm HV Wall Fan Model: DCWF50MB For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your fan for the first time and keep them in a safe place. WARNING – This appliance must not be used in a bathroom.
• • • • • • • • Children should be supervised to ensure they do not play with the appliance. WARNING: To avoid danger of suffocation please remove all packaging materials particularly plastic and EPS and keep these away from vulnerable people, children and babies. NEVER drop or insert any object or fingers into any openings. Do not use the appliance in locations where paint, petrol or other flammable liquids are used or stored.
Exposed to the weather outdoors 4 Near water If the power cable wires are frayed or cut Where small children may be left unattended If an extension lead may become overloaded Where the power cable may be damaged On a slope or uneven surface Where there is risk of fire or close to a naked flame Where it may be damaged by chemicals Where there is a risk of interference by foreign objects This product is not made for DIY repair If there is a risk of water falling on the unit
Specification Model no. DCWF50MB Colour Matte Black Power supply 220-240V~, 50/60Hz Rated power 135W Speed settings 19 Modes - Timer 1/2/4/8hr Tilt adjustable head Y Horizontal oscillation Y Noise level 73dB(A) Weight (net) Dimensions (w x d x h) 8.5kg 580 x 380 x 730mm • For greater precision, please always refer to the rating label placed on the product.
Parts 6. Motor shaft 2. Grub screw 4. Rear grille 7. Control panel/ screws display 1. Front grille 8. Fan motor 9. Motor fixing hole 10. Fixing bar hole & long bolt & washer. 15. Safety screw 5. Rear grille 11. Fixing bar 3. Fan blade 14. Bracket & fixing bar screws 12.
Assembly Mount to the wall 1. Determine the desired location of the wall fan (must be 1.8m from the floor) and ensure the wall is structurely sound to cope with the load of the fan. 2. Hold the wall bracket (13) in position, and mark the screw holes with a pencil. Ensure everything is marked horizontally and aligned before drilling. 3. Drill the holes where the pencil marks are to suit the 4 x fixing anchors (12). 4.
Operation The wall fan can be operated by the control panel, or the remote control. 1. Ensure the wall fan is plugged in and the power supplier is on. 2. Turn the fan ON by pressing the 'ON-OFF' button. 3. To adjust the speed, press the '+' or '-' button. The selected speed setting will show on the display panel. 4. If oscillation is required, press the SWING button, to start & stop oscillation. 5. The MEMORY button memorise the previous speed setting when OFF. 6.
Cleaning Over time, dust can accumulate on the front & rear grille cover and fan blades, which can affect the fans performance. It is recommended to clean the fan at least once a month. 1. Turn the unit OFF and disconnect the appliance from the power supply. 2. Remove any dust build up with a soft brush. 3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for any stubborn marks. Do not use abrasive sponges, scouring pads, or a stiff brush to clean the fan.
Maintenance If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 1340 Ferntree Gully Road, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
