INSTRUCTION MANUAL 81cm Tower Fan with Remote Model: DCTF81R For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your fan for the first time and keep them in a safe place. WARNING – This appliance must not be used in a bathroom.
• Never use the mains lead as a carrying strap or pulling lead. • To avoid a fire or electrocution hazard, NEVER put the cord near heat registers, radiator, stoves or heaters. • DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings. • DO NOT route cord under furniture or appliances. Take care to position the cord away from traffic areas and where it will not be a tripping hazard. • DO NOT use the unit near windows or where water collects.
WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN • Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus. • If you suspect your child has swallowed or inserted a button battery immediately call the 24-hour Poisons Information Centre on 13 11 26 (in Australia) or 0800 764 766 (in New Zealand) for fast, expert advice. • Examine devices and make sure the battery compartment is correctly secured, e.g.
Exposed to the weather outdoors Near water If the power cable wires are frayed or cut Where small children may be left unattended If an extension lead may become overloaded Where the power cable may be damaged On a slope or uneven surface Where there is risk of fire or close to a naked flame Where it may be damaged by chemicals Where there is a risk of interference by foreign objects This product is not made for DIY repair If there is a risk of water falling on the unit 5
Specification Model no. Colour DCTF81R Black Power supply 220-240V~, 50Hz Rated power 45W Speed settings 3 Modes 3 Timer 0-7.5 hours Air volume 18.10m³/min Oscillating 70 degrees Controls Cord storage Noise level (MAX) Weight (net) Dimensions (w x d x h) Button or remote N 54dB(A) 1.9kg 240 x 240 x 810mm • For greater precision, please always refer to the rating label placed on the product.
Parts Remote control & storage slot LED Display Air outlet Rear cover Base Remote POWER POWER SPEED/ON OSC SPEED/ON OSC TIMER MODE TIMER MODE 7
Assembly Please refer to the below instructions & diagram to assemble the base to the body of the tower fan. 1. Remove the base locking collar (4) (twist anti-clockwise). 2. Position the two base shells together (2 & 3) and feed the power cord (1) through the opening. 3. Close the base together by firmly tightening the 4 screws provided. 4. Attach the base onto the bottom of the tower fan by aligning the locking tabs with the corresponding slots. 5.
Operation This tower fan can be operated by the control panel or remote control. Please refer to 0.5h 1h 2h 4h H M L Mode the below diagrams for descriptions. 0.5h 1h 2h 4h HI MED LO Mode Button Controls Remote storage DE SPE E Timer button IM OSC Oscillation button On/Speed button ER O ON D/ M Mode button T OFF OFF button 0.5h 1h 2h 4h 0.
Operation Note: All functions of the unit can be operated by the control panel or remote control. 1. Place the fan on a flat stable surface and plug into a power outlet. 2. Press the SPEED/ON button to turn the unit ON and select the desired speed setting. 3. There are 3 SPEED settings – 1 (Low), 2 (Medium) and 3 (High). 4. Press the TIMER button the set the auto-off timer in 0.5 hour increments, up to a maximum of 7.5 hours. 5. Press the MODE button to seclect either Normal, Natural, or Sleep modes.
Cleaning Over time, dust can accumulate on the fan grille, which can affect the fans performance. It is recommended to clean the fan at least once a month. 1. Turn the unit OFF and disconnect the appliance from the power supply. 2. Remove any dust build up with a soft brush. 3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for any stubborn marks. Do not use abrasive sponges, scouring pads, or a stiff brush to clean the unit.
Maintenance If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 1340 Ferntree Gully Road, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
