Owner’s Manual Model EMC4240 DCH4831L IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this heater. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations . . . . . . . . . . . . . . . . 3 Important Instructions. . . . . . . . . . . . . . . 4 Heater Installation . . . . . . . . . . . . . . . . . . . . . . . . 6 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Maintenance and Cleaning. . . . . . . . . . . . . . . . . 8 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Replacement Parts . . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric heater from Dimplex, the world leader in electric heaters. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
Important Instructions ① Read all instructions before using this appliance. ② The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the unit.
Important Instructions not block air intake or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. is not intended for use with an extension cord. Plug the unit directly into a wall receptacle. ⑬ All electrical heaters have hot alarm (red light) to warn that parts of the heater are over heating. If the red light turns on, immediately turn heater off and inspect for any objects on or adjacent to the heater that may cause high temperatures.
Important Instructions Grounding Instructions This heater is for use on 240 Volts. The cord has a plug as shown on Figure 1. No adapter should be used with this unit. The type outlet is a 240 Volt grounding outlet. When properly installed, it provides a ground connection through the cord to the heater to protect the operation from electric shock.
Heater Installation Figure 3 Down Position Operation Setting the Thermostat 1. Before connecting or disconnecting plug, turn knob fully counterclockwise (Figure 4). 2. Heater is equipped with a thermostat. To adjust temperature to your individual requirements, turn thermostat control knob clockwise all the way to turn heater on, the yellow power light will illuminate (Figure 5). When room reaches desired temperature, turn thermostat knob counterclockwise until you hear a click.
Maintenance and Cleaning Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. CAUTION: Allow at least 30 minutes for the heater to cool before attempting any maintenance or cleaning. To clean the exterior surface, use a solution of water and mild detergent, apply with damp sponge. Wipe dry with a dry cloth. DO NOT plug heater into outlet until it has dried thoroughly.
Replacement Parts DCH4831A DCH4831L Fan Blade . . . . . . . . . .1900010022RP Fan Blade . . . . . . . . . .5300220100RP Motor Kit . . . . . . . . . . .2000020022RP Motor Kit . . . . . . . . . . .2000260300RP Element . . . . . . . . . . .2200070122RP Element . . . . . . . . . . .2200070122RP Thermostat . . . . . . . . . 09635002RP Thermostat . . . . . . . . .2600070100RP Cutout . . . . . . . . . . . . . 00009113RP Cutout . . . . . . . . . . . . . 00009112RP Knob - Clear . . . . . . . .
