INSTRUCTION MANUAL 40cm HV Floor Fan Model: DCFF40CH & DCFF40MBK For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your dehumidifier for the first time and keep them in a safe place. WARNING – This appliance must not be used in a bathroom.
Specification Model no.
Parts Assembly This fan has been partially assembled to reduce wastage of packaging material, paper cartons and weight. To assemble the fan grilles, blades and base, please follow the instructions below: 7. Rear grille 2. Front grille 9. Oscillation knob 6. Motor housing screws 8. Motor 10. Power cord 12. Lock nut 1. Logo ring 11. Neck 3. Blade 5. Front grille nut 1. Remove the protective sleeve (if any) from the motor shaft (8). 2.
Operation 1. Connect the plug to a power supply and switch on the power. 2. Switch the fan ON by rotating the speed switch knob at the rear in clockwise direction. This switch is also used to adjust the fan SPEED. Storage If you do not use the unit for an extended period of time. After cleaning please: • Turn the unit off, unplug and take care of the mains lead & plug. • Cover the unit and store it upright in a location where it will not receive direct sunlight.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 8 Lakeview Drive, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
