Owner`s manual

8 www.dimplex.com
Operation
Electric Fireplace Manual
Control
The manual controls for the
replace are located in the upper
right hand corner (Figure 1).
A. Main On/Off Switch
Supplies power to the 3 position
manual control switch.
B. 3 Position Manual Control
Switch
Remote (right position): The
unit is operated with the remote
control.
Flame (center position): The
ame effect is turned ON.
Flame & Heat (left position):
The ame effect and heater are
turned ON simultaneously. When
Figure 1
ABC
the manual control is in the Flame
& Heat position the heater does
not run on the remote operated
thermostat.
!
NOTE: When the manual
control switch is in the Flame
and Flame & Heat positions,
the replace unit will not
operate with the remote
control.
C. Initialization Button
Used to synchronize the remote
control.
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset.
The temperature cutoff switch
can be reset by unplugging the
unit, waiting ve (5) minutes and
plugging the unit back in.
CAUTION: If you need to
continuously reset the
heater, unplug the unit and call
Dimplex North America Limited