Owner`s manual

7
Site Selection and Preparation
!
NOTE 1: A 15 Amp, 120 Volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when
the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNING: Ensure the power
cord is not installed so that it
is pinched or against a sharp
edge and ensure that the
power cord is stored or
secured to avoid tripping or
snagging to reduce the risk
of re, electric shock or injury
to persons.
Construction and electrical
outlet wiring must comply with
local building codes and other
applicable regulations to
reduce the risk of re, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of re, electric
shock or injury to persons,
always use a licensed
electrician.
This section provides instructions
for selecting a location and
preparing the site to install the
replace into your Dimplex mantel
surround.
① Select a suitable location that
is not susceptible to moisture and
is away from drapes, furniture and
high trafc.
② For ease of electrical hook
up you may wish to locate the
replace near an existing outlet
(refer to NOTE 1).
③ Store the replace in a safe
dry and dust free location.
!
NOTE: The dimensions of
the replace are 44 inches
(1118 mm) wide X 34 inches
(883 mm) high X 11 5/8 inches
(295 mm) deep. The replace
does not require any additional
venting.