Owner`s manual

12 www.dimplex.com
Operation
2. Set Temperature
Press F button to turn replace
on.
Press H to raise thermostat.
Press G to lower thermostat.
Press both H and G to change °F
to °C.
3. Dimmer
Press the F button to turn the
Flame/Heat ON.
Repeatedly press the J or I button
to decrease or increase the
brightness of the upper lights.
4. Flame Speed
Press the F button to turn the
Flame/Heat ON.
Press the L button to increase the
speed of the ame.
Press the K to decrease the
speed of the ame.
5. Sleep Timer
The Sleep Timer automatically
shuts off the replace after a
preset time (from 30 minutes to 8
hours).
Press the F button to turn the
replace ON.
To set the sleep timer press the N
button.
Set the timer from 30 minutes
through 8 hours. The replace
will automatically turn off when
the sleep timer reaches zero (0)
minutes.
The sleep timer can be cancelled
at any time by pressing the M
button repeatedly until the sleep
timer displays “0”.
WARNING: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of re, electric
shock or damage to persons.
6. Flame & Heat On/Off Button
Press the F button to turn the
Flame/Heat function ON. When
B is higher then A the heat will
come on. To turn the heat off,
lower the B so that it’s setting
is lower then the A. The default
temperature setting is 72°F
(22°C).
!
NOTE: When using the
remote control the heater runs
on a thermostat. Press the
H or G buttons to adjust the
set temperature. Once the