Instructions / Assembly

8 www.dimplex.com
For ease of electrical hook 2.
up you may wish to locate
the replace near an existing
outlet (refer to NOTE 1).
Store the replace in a safe 3.
dry and dust free location.
Operation
Electric Fireplace Manual
Control
The manual controls for the
replace are located in the upper
right hand corner (Figure 1).
A. On/Off Switch
Supplies power to the 3 position
manual control switch.
B. 3 Position Switch
Remote (left position): The
unit is operated with the remote
control.
Flame (center position): The
ame effect is turned ON.
Flame & Heat (right position):
The ame effect and heater are
turned ON simultaneously. When
the manual control is in the Flame
& Heat position the heater does
not run on the remote operated
thermostat.
!
NOTE: When the 3-position
switch is in the Flame and
Flame & Heat positions, the
replace unit will not operate
with the remote control.
C. Initialization Button
Used to synchronize the remote
control.
Resetting The
Figure 1
ABC
Site Selection and Preparation
!
NOTE: The dimensions of
the replace are 44 inches
(1118 mm) wide x 34 inches
(883 mm) high x 11 5/8 inches
(295 mm) deep. The replace
does not require any additional
venting.