Instructions / Assembly
7
Quick Reference Guide
Prior to the rst use of the 1.
replace verify the following:
Are the circuit breakers for •
the unit on?
Are the light bulbs in your •
replace loose? (to check,
follow the instructions for
replacing the light bulbs
under the Maintenance
section of this manual)
The heater on your replace 2.
may emit a slight, harmless
odor when rst used. This
odor is a normal condition
caused by the initial heating
of internal heater parts and
will not occur again.
The information regarding the 3.
model of your replace can
be found on the rating plate
located on the front of the
unit.
Site Selection and Preparation
!
NOTE 1: A 15 Amp, 120
Volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases. A
dedicated circuit will be required
if, after installation, the circuit
breaker trips or fuse blows on a
regular basis when the heater is
operating. Additional appliances
on the same circuit may exceed
the current rating of the circuit
breaker.
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of re, electric shock or injury to
persons.
Construction and electrical •
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of re, electric
shock and injury to persons.
Do not attempt to wire your •
own new outlets or circuits. To
reduce the risk of re, electric
shock or injury to persons,
always use a licensed
electrician.
This section provides •
instructions for selecting a
location and preparing the
site to install the replace
into your Dimplex mantel
surround.
Select a suitable location that 1.
is not susceptible to moisture
and is away from drapes,
furniture and high trafc.