Installation Guide

10 www.dimplex.com
Operation
button on the unit.
7. Press the Flame/Heat On/Off
button to turn the Flame/
Heat function ON.
Frequency Interference
If the replace does not respond
properly to the remote control,
the remote operating frequency
may have to be reset. The
remote control can send another
frequency code to the circuit
board to eliminate interference.
1. Simultaneously press the
“Temperature Down” button
and the “Flame Speed
Down” button on the remote
control.
2. “COD” will appear in place of
the sleep timer digits.
3. Release the “Temperature
Down” button and the “Flame
Speed Down” button.
4. Press the initialization button
on the unit.
5. Press the button on the
remote.
Your remote will now
have a different frequency
communicating with the replace.
Remote Control Functions
(All letter references are to Figure 6)
B. Set Temperature
Press F button to turn re-
place on.
Press H to raise thermostat.
Press G to lower thermostat.
Press both H and G to change
°F to °C.
C. Dimmer
Press the F button to turn
the Flame/Heat on.
Repeatedly press the J or I
button to decrease or increase
the brightness of the upper
lights.
D. Flame Speed
Press the F button to turn
the Flame/Heat on.
Press the L button to increase
the speed of the ame.
Press the K to decrease the
speed of the ame.
E. Sleep Timer
The Sleep Timer automatically
shuts off the replace after a
preset time (from 30 minutes
to 8 hours).
Press the F button to turn
the replace on.