User manual

INSTALLATION AND USE MANUAL

Chapter 4

page 15

4. INSTALLATION AND ASSEMBLY

IMPORTANT!

The fireplace stove must be installed and connected

to the chimney flue only by a specialized technician,

so that all local and national regulations are complied

with.

Installation must in any case be carried out in

compliance with Building Regulations.

When the fireplace is unpacked, check for perfect operation of all

its parts or any damage which may have occurred during

shipping. The retailer or the carrier must be immediately

informed of any damage.

If the fireplace stove is installed in a place that is difficult to reach, its

weight can be reduced by removing the internal parts that make up the

fire box. However, be sure to put all of the parts back in place.

This operation is to be carried out only by specialized

personnel.

The company shall not be held liable if the preceding warning

is not complied with.

4.1. PREPARATION AND UNPACKING

Open the packaging, remove the stove unit from the pallet and position

it in the chosen location, taking care that its position complies with the

above instructions.

The fireplace stove must always be kept in a

VERTICAL position during handling, using the

appropriate handles located on the sides.

Be especially careful that the door and its glass are protected from

mechanical collisions that could jeopardise their integrity.

Moving the product must be done with care. If possible, unpack the

fireplace stove in the area where it is to be installed.

The materials which make up the packaging are not toxic or harmful,

so no special procedures for disposal are required.

The final user must store, dispose or recycle packaging material in

accordance with local regulations.

4.2. ELECTRICAL CONNECTION

If the optional forced ventilation kit has been specified, before

positioning the stove insert, a 230V - 50 Hz electrical power outlet must

be prepared near the insert in order to connect the electrical cable that

powers the forced ventilation fans.

The socket must be fitted with earth and must be accessible at all times

to cut off power when servicing equipment. The socket must be

protected from heat given through stove operation – observe safe

distances to combustibles at all times.

Example of fireplace stove packing