Product Manual

14 www.dimplex.com
will need to be synchronized.
!
NOTE: For ease of synchro-
nization it is suggested that the
controller be taken to each heater
to complete the synchronization
process.
1. Press the icon, this will put
the controller into synchroniza-
tion mode.
2. All four (4) zone icons will
begin to ash.
3. Select the zone that the spe-
cic heater will be associated
with, that icon will become
solid.
4. On the heater press and hold
the V button for 3 seconds,
both the and icons will
begin to ash.
5. Press the – , ✚ and then V,
on the heater.
6. Within 10 seconds press the
icon on the controller.
!
NOTE: When the synchroniza-
tion is complete the display on
the heater will switch to the new
settings from the controller.
7. Repeat steps 3-5 until all of
the heaters are synchronized.
8. Press the icon to revert
back to operation mode.
General Functions
5. Lock Function
The controller can be "Locked" so
that the display on the controller
are disabled to prevent any chang-
es to the settings in the system.
To Enable:
1. Press the Icon.
2. Enter the sequence Zone 1,
Zone 2, Zone 3 and Zone 4,
then press the Icon.
The Controller will display the
Icon and continue to operate
based on the settings and signals
from the controller.
!
NOTE: Adjustments can be
made to individual heaters by en-
tering it's specic unlock sequence
and adjusting the set point.
CAUTION: The adjusted
heater will only retain the new set
point until an event occurs on the
controller and a new set point is
sent.
To Disable:
1. Press and hold the Icon for
3 seconds.
2. Enter the sequence Zone 1,
Zone 2, Zone 3 and Zone 4,
then press the Icon.