Owner’s Manual Model CUH05B31T IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this heater. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.
Table of Contents Welcome & Congratulations. . . . . . . . . . . . . . . . . 3 Important Instructions . . . . . . . . . . . . . . . 4 Heater Installation . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Maintenance and Cleaning. . . . . . . . . . . . . . . . . . 8 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Replacement Parts. . . . . . . . . . . . . . . . . . . . . . . . .
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric heater from Dimplex. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. Please record your model and serial numbers below for future reference.
Important Instructions ① Read all instructions before using this heater. ② This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front, sides and rear of the heater. ③ Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
Important Instructions heater. ⑯ When transporting or storing the heater, keep in a dry place, free from excessive vibration and store so as to avoid damage. SAVE THESE Instructions Heater Installation HEATER LOCATION AND CLEARANCES The heater is to be installed in a fixed location. The discharge air should wipe the walls without blowing directly on them. (FIGURE 1) Ensure the air discharge is parallel to or away from walls.
Heater Installation direction from center, and tilted in a 45 degree range while suspended from the wall or ceiling. ! NOTE: The hardware for mounting the hanger bracket to the wall or ceiling is not included. CAUTION: When turning and/ or tilting the heater do not block the exhaust opening. The following steps are shown in Figure 3: 1. Locate a stud or other suitable support and install hanger bracket on wall or ceiling. Select location so control knob on back of heater can be reached easily. * 2.
Heater Installation conduit can be used. 4. 5. Remove junction box cover of CUH and remove one knockout hole. Insert approved bushing into hole and feed wire cable through. Tighten bushing around cable. diagram. Make connections using approved wire nut connectors and secure the grounding wire to the ground screw on the heater chassis. 6. Replace junction box cover of CUH. Make electrical connection to CUH according to relevant wire Operation Setting the Thermostat 1. 2.
Maintenance and Cleaning arning: Disconnect W power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Allow at least 30 minutes for the heater to cool before attempting any maintenance or cleaning. To clean the exterior surface, use a solution of water and mild detergent, apply with damp sponge. Wipe dry with a dry cloth. DO NOT re-energize unit until it has dried thoroughly.
Replacement Parts Fan Blade . . . . . . . . . .5300220100RP Motor Kit . . . . . . . . . . .2000260300RP Element . . . . . . . . . . .2200070622RP Thermostat . . . . . . . . .2600070100RP Cutout . . . . . . . . . . . . . 03005035RP Knob - Clear . . . . . . . .
