Use and Care Manual

6 www.dimplex.com
Sub-Compact Stove Installation
!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or blows
fuses on a regular basis when
the heater is operating. Addi-
tional appliances on the same
circuit may exceed the current
rating of the circuit breaker.
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord
is stored or secured to avoid
tripping or snagging to reduce
the risk of re, electric shock or
injury to persons.
Construction and electrical
wiring must comply with local
building codes and other appli-
cable regulations to reduce the
risk of re, electric shock and
injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of re, electric
shock or injury to persons, al-
ways use a licensed electrician.
Installation
① Make sure the unit’s Main On/
Off Switch is switched Off (refer to
operating instruction section).
② Plug the unit into a 15 Amp,
120 VAC outlet.
Quick Reference Guide
1. Prior to the rst use of the
Sub-Compact Stove verify the
following:
• Are the circuit breakers for the
unit on?
• Are the light bulbs in your
Sub-Compact Stove loose? (to
check, follow the instructions
for replacing the light bulbs
under the Maintenance section
of this manual)
2. The heater on your Sub-Com-
pact Stove may emit a slight,
harmless odor when rst
used. This odor is a normal
condition caused by the initial
heating of internal heater
parts and will not occur again.
3. If you have any technical
questions or concerns regard-
ing the operation of your Sub-
Compact Stove, or require
service contact Customer
Service at 1-888-346-7539
before returning the product
to the point of purchase.