Service Manual

8 www.dimplex.com
Surface Mount
(Figure 6)
Tools Required: Philips head screwdriver
CAUTION: Follow “Preparation for Service” instructions
before proceeding.
1. Partially unscrew the rear mounting screws that are
holding the replace to the wall along the back panel
of the unit. Support the weight of the replace when
loosening the screws so unit does not fall off the wall
unexpectedly.
!
NOTE: Be sure to take note of which keyhole mount
openings were used for positioning the replace so that
it can be re-placed in the same location when service is
complete. (Figure 6)
2. Take the replace off the wall by carefully lifting the
replace off the mounting screws so they line up to the
larger part of the keyhole openings and pull forward.
Carefully lay the unit down on a solid at surface with
the front of the unit facing up.
!
NOTE: If the surface you are using as a work area on
is a nished surface that is prone to scratches (i.e. hard-
wood ooring), it is recommended that a protective barrier
be used underneath, (i.e. cloth, cardboard, thick plastic).
3. Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.
4. Once repair is complete, reassemble in the reverse
order as above.
Recessed Mount - Partial In-wall
(Figure 7)
Tools Required: Philips head screwdriver
CAUTION: Follow “Preparation for Service” instructions
before proceeding.
1. Remove the 4 mounting screws located approximately
3 inches deep in the space between the outer and
50
5
16
" (128 cm)
19
1
2
(49.5 cm)
46" (116 cm)
48
1
2
" (123 cm)
3" (7.6 cm)
7"
(17.8 cm)
3
13
16
"
(9.7 cm)
18"
(45.7 cm)
16"
(40.6 cm)
Figure 5
Figure 6
Key-hole
Wall stud
Permanent
mounting hole
Mounting Holes
Figure 7