Owner's Manual

9
Figure 3
Partially
Reective Glass
Glass Bracket
Bracket Screws
replace.
Hardwire Installation
The replace is packaged with
a three prong plug installed for
plug-in convenience. Hard wiring
the replace is also an option for
any installation.
WARNING: Do not attempt
to wire your own new outlets
or circuits. To reduce the risk
of re, electric shock or in-
jury to persons, always use a
licensed electrician.
WARNING: Ensure that the
circuit on which the replace is
to be installed has the power
cut off at the service panel
until installation is complete.
1. Remove the partially reective
glass from the replace:
Fireplace Installation
Front Panel
Front Panel tabs (2)
Acrylic Tray screws (4)
Metal Tray
Screws (4)
Figure 4
• Lay replace on its back.
• Remove two Phillips screws
from each of the two glass
brackets (Figure 3).
• Remove glass brackets.
• With one hand keeping pres-
sure on the partially reective
glass, tilt the replace upright
and slightly forward to allow
the partially reective glass to
fall out of the inside framing.
CAUTION: Partially reective
glass is not tempered. Do not
bump or drop the partially reec-
tive glass to avoid breakage and
personal injury.
• Remove partially reective
glass from replace.
2. Locate the power cord and
remove the 3 screws that at-
tach the metal bracket to the