Warranty

9
Figure 3
Screws
Electrical
Cord Bracket
Figure 4
Wire Access
Covers
Hardwire
Bracket
Fireplace Installation
Hardwire Installation
The replace is provided with a three
prong plug installed for plug-in con-
venience. Hard wiring the replace is
also an option for any installation.
WARNING: Do not attempt to wire
your own new outlets or circuits. To
reduce the risk of re, electric shock
or injury to persons, always use a
licensed electrician.
WARNING: Ensure that the circuit
on which the replace is to be
installed has the power cut o󰀨 at
the service panel until installation
is complete.
1. Carefully remove the electrical
cord bracket from the back of the
replace by removing the three
retaining screws. (Figure 3)
2. Remove the two wire access
covers o󰀨 of the unit at the front
to access the wire connections.
(Figure 4)
3. Pull the wires and connectors out
of the back opening.
4. Unscrew the three wire connec-
tors inside the electrical box and
separate the wires.
5. Install the supplied hardwire
bracket (with the ½" wire hole)
onto the rebox. (Figure 3)
6. Leaving a minimum of 3 in. (7.6
cm) of slack, route the power
supply wires through the hole in
the electrical cover bracket and
secure with a wire clamp (not
supplied).
7. Connect the black wire (L) from
the unit to the live wire from the
power supply using one of the
wire connectors removed in step
4.