Prism Series Owner's Manual

8 www.dimplex.com
Fireplace Installation
is equipped with a cord having an
equipment-grounding conductor and
a grounding plug. The plug must be
plugged into an appropriate outlet
that is properly installed and ground-
ed in accordance with all local codes
and ordinances.
DANGER: Improper connection of
the equipment-grounding conductor
can result in a risk of electric shock.
Check with a qualied electrician or
serviceman if you are in doubt as
to whether the product is properly
grounded. Do not modify the plug
provided with the product – if it will
not t the outlet, have a proper outlet
installed by a qualied electrician.
This product is for use on a nominal
120-volt circuit and has a grounding
plug that looks like the plug in Figure
1. Make sure that the product is con-
nected to an outlet having the same
conguration as the plug. No adapter
should be used with this product.
AC/DC ADAPTER
RELAY BOARD
SWITCH BOARD
DISPLAY / CONTROL BOARD
LINE
NEUTRAL
HTR
THERMISTOR
LED STRIPS (RGB) - MEDIA
FLAME LED STRIP (AMBER)
M
ELEMENT
ELEMENT
CUTOUT
THERMAL
M
FLICKER MOTOR
BLOWER MOTOR
LED STRIPS (RGB) - FLAME
Wiring
Hardwire Installation
The replace is provided with a three
prong plug installed for plug-in con-
venience. Hard wiring the replace is
also an option for any installation.
WARNING: Do not attempt to wire
your own new outlets or circuits. To
reduce the risk of re, electric shock
or injury to persons, always use a
licensed electrician.
WARNING: Ensure that the
circuit on which the replace is to
be installed has the power cut off
at the service panel until installa-
tion is complete.
1. Carefully remove the electrical
Figure 2