Prism Series Owner's Manual

13
Figure 9
2 x 8 Framing
Figure 10
Mounting hole
Mounting hole
Wall
surface
Fireplace Installation
instructions on page 8.
WARNING: Do not attempt to wire
your own new outlets or circuits. To
reduce the risk of re, electric shock or
injury to persons, always use a licensed
electrician.
WARNING: Ensure that the
circuit on which the replace is to
be installed has the power cut off at
the service panel until installation is
complete.
3. Lift replace and insert into open-
ing. The replace's mounting trim
should be ush against the wall
(Figure 9).
4. Use the supplied bubble level to
level the replace within the fram-
ing, adjust as required.
5. Drive four supplied mounting
screws through the four mounting
holes located on the inside surface
of the replace chassis, into wall
studs (Figure 10).
6. Refer to Front Glass Installa-
tion section for nal installation
procedures.
Front Glass Installation
1. Pour and evenly distribute the
supplied media in the Media tray
of the firebox(Figure 11).
2. Carefully mount front glass as-
sembly so that the front glass
hooks hang on the front glass
mounts on the fireplace (Figure
11).
3. Use the supplied two Phillips
sheet metal screws to fasten the
glass assembly tabs to the fire-
place (Figure 12).
4. If unit is not hard-wired, plug
fireplace into a 15 Amp, 120 Volt
outlet (refer to NOTE 1).