Use and Care Manual

15
Fireplace Installation
3. Lift the replace and insert into the
opening. The replace's mounting
trim should be ush against the
wall (Figure 13).
4. Use the supplied bubble level
to level the replace within the
framing. Adjust as required.
5. Drive four supplied mounting
screws through the four mounting
holes located on the inside surface
of the replace chassis, into wall
studs (Figure 13).
6. Refer to Front Glass Installation
section for nal installation
procedures.
Figure 13
Mounting hole
Mounting hole
Wall
surface
Installation in a Dimplex
Media Console
1. Insert the replace into the
opening of the media console from
the front.
2. Drive four supplied mounting
screws through the four mounting
holes located on the inside surface
of the replace chassis, into the
walls of the media console.
3. Refer to Front Glass Installation
section for nal installation
procedures.