Use and Care Manual

12 www.dimplex.com
Figure 9
Key-hole
Wall stud
Permanent
mounting hole
Surface Installation
CAUTION: Two people may be
required for various steps of this
procedure.
1. Choose a location which has
a minimum of two wall studs
available for mounting.
2. Choose your method of supplying
power to the unit:
• Plug into an existing outlet or
install an outlet nearby.
• Hardwire the replace - follow the
hardwiring instructions on page 9.
3. Remove the partially reective
glass from the replace:
• Lay the replace on its back.
• Remove the two Phillips screws
from each of the two glass
brackets (Figure 3, page 9).
• Remove the glass brackets.
• With one hand keeping pressure
on the partially reective glass, tilt
the replace upright and slightly
forward to allow the partially
reective glass to fall out of the
inside framing.
CAUTION: Do not bump or drop
the partially reective glass to
avoid breakage and personal
injury.
• Remove the partially reective
glass from the replace.
4. Position the replace on a wall
at the position where it will be
mounted (Figure 9). Use a bubble
Fireplace Installation
level (one is supplied) to ensure
that replace is level on the wall.
5. Ensuring that at least two
keyholes line up with a wall stud
(keyholes are spaced at 4 in. (10.2
cm) centers), mark the location
of the four screw locations on the
wall (through the keyholes).
6. Remove the fireplace from the wall
and store it in a safe place away
from traffic.
7. Where marked screw locations do
not line up with a wall stud, insert
(screw in) one of the two supplied
wall anchors (pre-drill if required).
Repeat if only two screws line up
with a wall stud.
8. Screw all four supplied #8, 1½ in.
(3.8 cm) square head mounting
screws and washers into the wall
and/or wall anchors leaving ¼ in.
(6.5 mm) of thread.
9. Align the chosen keyholes with