Service Manual

15
8. Properly orient the new cutout and reconnect all of the
wiring connections.
9. Reassemble in the reverse order as above.
!
NOTE: See Helpful Hints Section for reassembly.
BLOWER ASSEMBLY REPLACEMENT
Tools Required: Phillips Head Screwdriver
Flat Head Screwdriver
WARNING: If the replace was operating prior to
servicing allow at least 10 minutes for light bulbs and
heating elements to cool off to avoid accidental burning
of skin.
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
1. Remove the unit from the wall.
2. Remove the 9 screws along the left, right and back
edge of the top panel
3. Carefully lift and reposition the top panel inside the
upper cavity to access the upper components. Use
care to not damage the wires attached to the upper
panel when repositioning.
4. From under the elements, remove the 3 screws found
on the inside top of the heater assembly housing.
These screws secure the heater assembly housing to
the top panel of the rebox.
5. Grasp the heater assembly housing and pull it down,
guiding the 3 housing mounting tabs above the fan to
release from the top panel.
6. Remove the wire connections from the heater/blower
assembly, noting their original locations
!
NOTE: Using a at head screwdriver gently pry be-
tween the end of the connector and the switch to release
the wires.
7. Properly orient the new blower assembly and recon-
nect all of the wiring connections.
8. Reassemble in the reverse order as above.
!
NOTE: See Helpful Hints Section for reassembly.
HELPFUL HINTS FOR REASSEMBLY
Upper Vent Panel: When replacing the upper vent panel,
only partially tighten the rst 2 screws, (one on the left and
one on the right) to allow for easier alignment of the panel.
This allows a small amount of room for adjustment when
aligning the panel. Once the screw holes are completely
aligned, proceed to tighten those 2 screws and the replace
the remaining screws from the upper panel.
Partially reective glass: When replacing the partially
reective glass, insert the top end rst behind the upper
vent panel and then rest the bottom on the lower ledge.
Carefully hold the partially reective glass in place and re-
secure it with the (2) mounting tabs with screws along the
lower ledge.
Figure 4
Log-Set: When re-installing the log set, connect the
Logset LED wire harness to the LED driver/wire harness
plug inside the replace. Reinsert logset along the opening
on the front inside edge of the replace, ensuring the wire
harness is underneath the log- set. Push the backside of
the log-set down until the rear tab snaps under the back
partially reective glass ledge and the logs are resting
against the partially reective glass.
!
NOTE: Occasionally, if the log-set seems to be a very
tight t, you can put the back side of the log-set in rst,
then carefully guide the front of the log-set down into the
opening using a at head screw driver for leverage.
BFSL33DOOR (optional front glass accessory):
When re-inserting the BFSL33DOOR, the pins and bolts
should be tight enough to secure the door, but loose
enough to allow some room for adjustment. In order to align
the pins and the receiver openings, in the front frame of the
rebox, the longer door pins should go into the top receiver
openings rst, then lift the door from the bottom and guide it
into the bottom receiver openings. (Figure 4)