Service manual

11
7. Properly orientate the new switch and push it through
the sheet metal from inside the rebox. Push until the
retainer clips on either side of the switch snap into place.
8. Re-connect the two (2) wire clips to the back of the
switch.
9. Reassemble in the reverse order as above.
SwitchBoardReplacement
If the replace was operating prior to servicing allow at least
10 minutes for light bulbs and heating element to cool off to
avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
ReplacementProcedure
1. Remove the rebox from the mantel.
2. Remove the eight (8) Philips screws that fasten the top
cover to the rest of the rebox. There are: three (3)
screws on each side along the top edge; and two (2)
screws on the back along the top edge (Figure 12, Page
10).
3. Flip the top panel over and rest it on the top of the
replace.
 CAUTION:Use caution when ipping top panel over as
there are components attached to the top panel which
are wired to the internal cavity of the replace.
4. Open the bi-fold doors and steel curtain.
5. Locate the Switch Board mounted on the top of the
replace on the right side (Figure 14) and disconnect
the one (1) wide white ribbon cable noting its original
location.
7. Properly orientate the new Switch Board, snap onto
the mounting studs and reconnect the ribbon cable as
before.
8. Reassemble in the reverse order as above.
FlickerMotor/FlickerRodReplacement
If the replace was operating prior to servicing allow at least
10 minutes for light bulbs and heating element to cool off to
avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
ReplacementProcedure:
1. Slide fireplace out from mantel.
2. Open the bi-fold doors and steel curtain.
3. Pull the front edge of the plastic ember bed or plastic
grate up and forward until the rear tab releases from the
ledge located at the bottom of the mirror (Figure 5,
Page 8).
!
IMPORTANT:Only handle the log set by the ember bed.
!
NOTE:Log set ts tightly into rebox, some force may
be necessary to remove.
4. Set log set in front of replace.
5. Disconnect the log set LED wire harness from unit
(Figure 5, Page 8).
6. Pull the Flicker Rod to the far right, then bend it carefully
to free and lift the left side out of the mounting bracket
(Figure 15).
!
 NOTE: When removing the Flicker Rod, damage may
occur if bent excessively. If the Flicker Rod is damaged,
replace to insure proper operation.
Figure 14
Wide white ribbon
cable to Circuit Board
Mounting
Studs (2)
Switch Board
6. The Switch Board is fastened to the sheet metal by
two (2) mounting studs, one on each side (Figure 14).
Squeeze both mounting stud’s clasp to release and
remove the Switch Board.
Figure 15
Exploded view used for clarity
Flicker Rod
Flicker
Motor
Screws
(2)