Project Ideas

STEP 8
Mark and predrill 16 pilot holes for the 3/4” black screws (top-row photos
below). Use a drill extender to attach the flange feet to the top shelf of
the bar cart using a Phillips head driver bit (bottom-row photos).
STEP 9
Lay the bar cart on its side. On the underside of the bottom shelf, place
a caster wheel at each corner and mark for predrilling (top left photo
below).
Measure and mark your drill bit with a piece of tape to avoid drilling all
the way through the bottom shelf (top right photo).
Predrill 16 pilot holes for the 3/4” slotted hex washer head screws (bottom
left photo).
Attach the caster wheels to the bottom of the bar cart using a hex
head driver bit (bottom right photo).
page 6 of 7