Operation Manual

Dimension BST 768 / SST 768 User Guide
Troubleshooting
Troubleshooting Checklist
Problem or error message Solution
No power Verify power cord is securely plugged in.
Verify that the circuit breaker (at rear of system)
and the power switch (on right panel of system)
are both in the ON position.
Verify AC power is present at wall outlet.
System fails to reach operating
temperatures
Verify the system is not connected to an
extension cord or power strip.
Material not extruding Filament may be jammed in extrusion head (see
“Loss of Extrusion” on page 59).
Purge material accumulating on
part.
Make sure that the flicker and brush are set to the
proper height. (See “Tip Cleaning
Assembly (Brush/Flicker Assembly)”
on page 49.
)
Check condition of Flicker and Brush. Replace if
worn. (See “Tip Cleaning Assembly
(Brush/Flicker Assembly)” on
page 49.
)
No text displayed on Display
Panel
Cycle power (see “Cycling Power” on page 33).
Cannot communicate with system
through network
Make sure network cables are connected - at the
printer, at the PC, and where cables connect to
network boxes.
Re-configure settings per (see “Networking Your
Printer” on page 23).