Operation Manual

Dimension BST 768 / SST 768 User Guide
Operation 37
Figure 13: Close-up of extrusion tips
NOTE
If the display shows
Load Failed, press Retry. If load fails
again, remove the cartridge, snip the material (see
Figure 12 on
page 36), remove filament in the printer, and reinsert the
cartridge.
Unloading Material
The model and support material cartridges may be replaced
separately or at the same time. In idle-, load-, or build-related
modes, the panel displays the percentage of material remaining in
the cartridges. If the printer will be operating unattended for a long
period, and the material level is getting low, you may want to
replace the cartridges before starting a new part. Of course, you
will also need to replace the cartridges when they are empty.
Unload material cartridges:
1. From Idle (or Ready To Build), Press Material Load.
A. The panel displays Load Material and prompts with,
Replace model?
• Press Yes. to unload the Model Material.
The panel displays Replacing model,
• Press No if you do not wish to unload the model
material.
Model Tip
Support Tip