Operation Manual

Dimension BST 768 / SST 768 User Guide
Setup 29
Figure 8: Modeling base with test_tipdep_plstc.cmb model
5. Evaluate the etched numbers in each of the six groups. The
etched numbers must meet the following criteria:
• -5 must be visible in at least one of the six groups.
• +10 must not be visible in any of the six groups.
NOTE
The etched numbers can be difficult to see. It may be
necessary to tilt the modeling base to the light for
inspection.
It is acceptable for some groups to have NO visible etched
numbers. To meet the criteria, only one of the six groups
must have a visible -5.
6. If the tip depth does not meet the above criteria, run the model
a second time on a second unused modeling base and
evaluate again.
7. If the tip depth again fails the above criteria, contact your
Dimension service provider for more information on adjusting
tip depth.
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
-5
0
+5
+10
Extruded Numbers - SST
Etched Numbers - BST
(left side)
Etched Numbers - SST
Extruded Numbers - BST
(right side)