Operation Manual

20 Setup
Dimension BST 768 / SST 768 User Guide
Powering On Dimension
Dimension’s power switch is located on the right (viewed from the
front) side cover of the cabinet, near the bottom front corner (see
Figure 6). After the switch is pushed, Dimension boots up in three
to seven minutes.
Figure 6: Location of Power Switch
(View From Right SIde of Printer)
WARNING
Dimension’s build chamber and
extrusion-head tip get very hot! The
chamber and head tip reach
temperatures of approximately 75° C
(167° F) and 280° C (536° F) respectively.
Personal injury can occur if proper
techniques and safety materials are not
used. Use the leather safety gloves
provided in the Startup Kit when working
inside the printer.
CAUTION
Remove the foam tubes that isolate the
extrusion head from the frame (see
Figure 3 on page 17). The printer will be
damaged if powered on with the foam
tubes in place.