Operation Manual

Dimension BST 1200 / SST 1200 User Guide
Maintenance 55
Figure 23: Identifying Tips
C. With gloved hand, insert the new tip into the heater block.
D. Use needle nose pliers to grasp the stainless steel shield
of the tip.
E. Pull the tip shield toward you, then lift up to install the tip.
F. Push the tip toward the back of the printer once it is all the
way up against the heater block.
G. Verify the tip is fully inserted into the heater block and that
the stainless steel shield is aligned (See Figure 24 on page
56).
CAUTION
For a Dimension SST: Model and
SOLUBLE support tips are different. The
correct tip must be installed in the
correct side.