Operation Manual

54 Maintenance
Dimension BST 1200 / SST 1200 User Guide
C. Pull the tip shield toward you, then pull down to remove the
tip. Discard the used tip.
Figure 22: Tip Removal
4. Install Tip
A. For a Dimension BST, the SUPPORT tip and MODEL tip
are interchangeable. Both tips are the same as the
MODEL tip shown in
Figure 23 on page 55. (The tips come
in a Red capped container).
B. For a Dimension SST, you must identify the correct
replacement tip. The SST uses two tip types. You must
make sure a SUPPORT tip is used on the LEFT side of
the head assembly. A MODEL tip must be used on the
RIGHT side of the head assembly (See Figure 23 on page
55). The Model tip comes in a Red capped container. The
Support tip comes in a Black capped container.