Operation Manual

Dimension BST 1200 / SST 1200 User Guide
Operation 41
Canceling a Job
You can cancel a job at any time while the part is building.
Cancel a job:
1. Press Pause.
2. Once Dimension stops building, press Cancel Build.
The panel displays Are you Sure?
3. Press Yes. The panel displays Build Stopped followed by
the part name.
• The panel prompts you to remove the part and replace the
modeling base (See “Inserting a Modeling Base” on
page 30.). Once the chamber door has been opened and
closed, the panel asks: Part Removed?
4. Press Yes only after removing the part - refer to “Removing a
Completed Part”.
Removing a Completed Part
When the part has completed, the panel displays Completed
Build, and the file’s name. It also shows Remove Part and
Replace Modeling Base.
Remove a completed part from the Dimension system:
1. Open the modeling chamber door.
2. Release the modeling base retainers and pull the modeling
base towards you, out of the tray guides.
3. Insert a new modeling base.
4. Close the modeling chamber door.
CAUTION
If you press
Yes before removing the
part, the system can be damaged, and a
service call will be required.