Product Info

OTDR
25
3.3.4 Check Ethernet and WiFi status
Before OTDR software starts, it is necessary to ensure that Ethernet is fully
configured, Ethernet is on and WiFi is off. Click the system tool icon in the main
interface, then click the setting icon, and then click Network and Internet. After
entering the network setting page, you will see the network status setting column
as shown in figure 3.2-2. Please ensure that the WLAN column is turned off and
the Ethernet column is turned on.
Figure 3.2-2 Network settings page
3.3.5 Configure Ethernet
Ethernet is set by default when leaving the factory, but if the Ethernet data is
cleared due to deletion of Ethernet data, update of underlying driver and other
misoperations, there will be problems in the communication between GAMMA
and OTDR module. At this time, it is necessary to reconfigure the Ethernet.