Owner's Manual

Dimension One Spas - Bay Collection - Owner’s Manual
27
Light Bulb Replacement
1. Turn the power off at the GFCI breaker and drain
the water to below the level of the light.
2. Using the special tool provided in the owner’s
manual packet, unscrew the lens that covers the light
housing.
3. Remove the old bulb and install the new bulb.
4. Use the special tool to replace the lens on the light housing.
5. Turn the light on and off to make sure it works before refilling the spa.
Do not attempt to remove the lens without draining the water to below the
level of the light.
Do not attempt to remove the lens without the special tool. If it is lost, contact
your Dimension One Spas Service dealer to have one sent.
Be sure the rubber O-ring behind the lens is undamaged and is properly
positioned when replacing the lens. Contact your Dimension One Spas dealer
if you need a replacement O-ring.
Spa Surface Care
It is recommended that a “cheesecloth” rag, or other soft rag, is used to clean the entire shell
surface with Water Line Cleaner or a similar product from your spa dealer. Or use ph/Alkalinity
Increaser or a 50/50 solution of denatured alcohol and water. Be sure to thoroughly rinse the
shell after cleaning. To restore the luster of the shell after cleaning, use Poli-Gloss or a similar
product from your spa dealer.
Do not use “409” type cleaners or other caustic solutions as they may damage
the shell surface and void the warranty. If you are using baking soda to clean
the hot tub shell, be careful not to get it on the wood skirt. It may bleach the
wood.
Do not use citrus-based cleaners on the shell surface.
Colored Shells: If the spa has a colored shell keep the spa covered even when
it contains no water. Sunlight can damage the spa surface and cause it to peel
or blister.