Dimension One Spas - Bay Collection - Owner’s Manual Spa Information My Spa Model Name: Serial Number: Date Purchased: Date Installed: Gallons/Liters: Notes: Dealer Information: Dealer’s Name: Address: i City: State, Zip: Telephone: Fax:
Dimension One Spas - Bay Collection - Owner’s Manual Table of Contents IMPORTANT SAFETY INSTRUCTIONS ................................................................................................. 1 HYPERTHERMIA ..................................................................................................................................... 4 SAFETY DO’S AND DON’TS .................................................................................................................. 4 WARNING SIGNS .......
Dimension One Spas - Bay Collection - Owner’s Manual IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • • • • • 1 READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY When installing and using this equipment, basic safety precautions should always be followed, including: Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents, ensure that children cannot use or approach the spa unless they are supervised at all times.
Dimension One Spas - Bay Collection - Owner’s Manual • • • • • To Reduce the Risk of Injury: Persons using medication should consult a physician before using a spa since some medication may induce drowsiness, while other medication may affect heart rate, blood pressure, and circulation. Observe a reasonable time limit when using the spa. Long exposures at high temperatures can cause high body temperature. Symptoms may include dizziness, nausea, fainting, drowsiness, and reduced awareness.
Dimension One Spas - Bay Collection - Owner’s Manual • • • • • • • • • • • • • • • • • • • • • • • AVERTISSEMENT: LES PERSONNES QUI PRENNENT DES MÉDICAMENTS OU ONT DES PROBLÈMES DE SANTÉ DEVRAIENT CONSULTER UN MÉDECIN AVANT D’UTILISER USE CUVE DE RELAXATION. People with infectious diseases should not use a spa or hot tub. AVERTISSEMENT: LES PERSONNES ATTEINTES DE MALADIES INFECTIEUSES NE DEVRAIENT PAS UTILISER UNE CUVE DE RELAXATION.
Dimension One Spas - Bay Collection - Owner’s Manual Hyperthermia Prolonged immersion in hot water may cause hyperthermia. A description of the causes, symptoms, and effects of hyperthermia are as follows: Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6° F, or 37° C. The symptoms of hyperthermia include dizziness, drowsiness, lethargy, and fainting.
Dimension One Spas - Bay Collection - Owner’s Manual Warning Signs Each spa has been provided with a Warning Sign and an Important Notice label. This label outlines safety precautions. This sign should be permanently placed in a location that is visible to the spa user.
Dimension One Spas - Bay Collection - Owner’s Manual Initial Startup IMPORTANT: About your GFCI Circuit Breaker — The GFCI (Ground Fault Circuit Interrupter — also called a "circuit breaker") is an electrical safety switch that automatically shuts off power to the spa in case of an electrical malfunction. There must have a GFCI installed according to local building codes in an electrical power box near your spa. The GFCI should be OFF before the spa is filled.
Dimension One Spas - Bay Collection - Owner’s Manual 6. Examine the jet pumps on the sides of the spa. There are two pump unions and two gate valves per pump. Check to make sure the pump unions are hand tight to prevent leaks. Next, check the gate valves to make sure they are fully opened (handles extended) and that the red safety clips are snapped into place. 7. Remove the shipping bolts from the base of each pump and rotate the swivel lock, located at the rear of each pump, away from the pump. 8.
Dimension One Spas - Bay Collection - Owner’s Manual 10. Remove the cap from the UltraPure™ filter canister and the filter basket from the skimmer canister. UltraPure™ Filter 13. Skimmer Filter 11. Remove the foam blocks securing each filter. 12. Next, remove the filter from the UltraPure™ canister and fill your hot tub by placing a hose into the empty UltraPure™ canister (for more details on removing the filter, see the Filter Cleaning section).
Dimension One Spas - Bay Collection - Owner’s Manual Depending upon the size of the hot tub and the size of the circuit breaker used, heating will occur at the rate of 3° F (≅2° C) to10° F (≅5° C) per hour. 18. While the spa is heating, inspect the pump unions and plumbing fittings for leaks. When the inspection is finished, replace all the equipment panels. 19. After completing the above steps, see the Water Care Guide (provided separately) to ensure proper water chemistry. 20.
Dimension One Spas - Bay Collection - Owner’s Manual Operation Using Your Control Panel: Push the screen selection button next to any item to turn on that item. When active, the ring around that item will spin. Push the button again to turn off the item. In a menu, push the button next to an item to bring up that item. Navigation The 5-Key Context Keypad The 5-Key Context Keypad buttons access and change spa settings quickly and easily.
Dimension One Spas - Bay Collection - Owner’s Manual Spa Menu The Hotkey The Hotkey allows the spa to display different sets of information on the screen while still giving access to the main controls. Pushing the Hotkey changes the information displayed in the center of the Spa Menu in the following sequence: Temperature Screen The Temperature screen displays the current spa temperature and sets the desired spa temperature . Clock Screen The Clock screen displays the current time of day.
Dimension One Spas - Bay Collection - Owner’s Manual Adjusting Temperature Summer Mode From the Temperature screen, push the up or down arrow on the 5-Key Context Keypad to enter the Setpoint screen. In this screen, use up and down to select the desired temperature. Press Accept to save the changes. During hot weather, normal filtering can cause the spa to exceed the set temperature, which stops the circulation pump so the spa can cool.
Dimension One Spas - Bay Collection - Owner’s Manual Amplifier Menu Page 1 MAIN > Presets Page 2 MAIN > > The icons 1, 2, 3 and 4 correspond to presets for the Sonic Immersion System Amplifier. Presets allow the spa to save or recall settings of the Sonic Immersion Systems Amplifier, such as subwoofer level, speaker level, bass, treble, and source input. A short press of a preset button will load that preset.
Dimension One Spas - Bay Collection - Owner’s Manual Adjusting Stereo Settings On the Amplifier menu, press Subwoofer, Speaker Level, Balance, Bass or Treble to bring up that parameter’s adjustment menu. In these menus, use the up and down arrows on the 5-Key Context Keypad to adjust that setting. Press Exit to leave the menu.
Dimension One Spas - Bay Collection - Owner’s Manual Runtime Adjusting Runtime Pressing the Runtime button brings up the Runtime Setting menu. This menu adjusts how long the jets and waterfall run. Push the Jets or Waterfall button to bring up that item’s Runtime screen. On this screen, use the up and down arrows on the 5-Key Context Keypad to select how many minutes each cycle will last. Press Accept to save the changes. Temperature Units Push the Temp.
Dimension One Spas - Bay Collection - Owner’s Manual Lock Function Use the up and down arrows on the 5-Key Context Keypad to control others’ access to the spa’s controls. Choose Unlock to allow access to all spa functions. Choose Partial Lock to lock programmable features but allow control of the jets, waterfall, light and stereo. Choose Full Panel Lock to lock all spa functions. Press Accept to save the changes.
Dimension One Spas - Bay Collection - Owner’s Manual System Reset Reminders Warnings Cleaning Your If the The system reset menu resets all parameters to the factory defaults. To proceed and reset all settings, press Reset. To go back and keep your settings, press Back. Occasionally, a maintenance reminder will appear on the screen. Some messages have an arrow below the last line; push Down on the 5Key Context Keypad to read the remainder of the message.
Dimension One Spas - Bay Collection - Owner’s Manual Dynamic Massage Sequencer™ The Dynamic Massage Sequencers control the jets in the lounge areas to sequentially massage different muscle groups. When selecting a massage sequence, the human figure on the control panel displays corresponding lights, allowing a preview of that sequence before starting it.
Dimension One Spas - Bay Collection - Owner’s Manual Sequence Button The Sequence button chooses between the six different massage sequences. The light glows to indicate the current sequence. When all jets are operating at once (the default mode) none of the sequence lights will glow. Massage Zones The lights in the Massage Zone Indicator (Human Figure) show which zone is currently selected. When the desired sequence is found with the Sequence button, press the Start/Stop button to start your massage.
Dimension One Spas - Bay Collection - Owner’s Manual Features Unique to Certain Models Selector Valves, Flow Controls, Switches, and Jet Pillows If the spa is equipped with any of the following features and controls, use them as described below to adjust the spa performance. Jet Zone Selector Rotate this knob to change the flow of water from one group of jets to another.
Dimension One Spas - Bay Collection - Owner’s Manual Water Features Babbling Brook Feature Umbrella Feature Depending on the model, the spa may have the babbling brook fountain shown at right.To adjust the flow of the fountain turn the flow control knob located near the spa’s Control Panel. Depending on the model, the spa may have the umbrella fountain shown at right. The fountain contains two adjustable parts – the barrel and the spreader.
Dimension One Spas - Bay Collection - Owner’s Manual SoftTouch™ Lighting SoftTouch Lighting Pagodas See the Light Operation section on page 12 for more information. The light pagodas on the spa are interchangeable. Pull up on the pagoda to remove it from its slot and then insert another pagoda in its place. HydroSport Aquatic Fitness Gear (Aftermarket Accessory) On certain models, the optional HydroSport™ Aquatic Fitness Gear can convert the spa into a powerful upper-body exercise system.
Dimension One Spas - Bay Collection - Owner’s Manual iWatch Perimeter Lighting System The iWatch control panel on the side of the spa skirt provides spa status information and colorful perimeter lighting. The iWatch functions can be controlled directly from this panel or by using the optional D1 Remote control.
Dimension One Spas - Bay Collection - Owner’s Manual Using the iWatch Lighting To control the iWatch perimeter lighting, press the Water Drop Button on the iWatch panel.
Dimension One Spas - Bay Collection - Owner’s Manual Routine Equipment Maintenance Draining Your Spa The spa is gravity-drained, without the need for a pump. To drain the spa, locate the hose bib, which was attached to the spa in the Initial Setup operation (described earlier), on the base near the lower left side of the equipment panel. Remove the cap (if any) from the hose bib.
Dimension One Spas - Bay Collection - Owner’s Manual Cleaning the Filter Screens The Filter Screen is a black plastic perforated cylinder located at the bottom of the canister that holds the filter. It normally requires no maintenance. However, if the spa frequently says to clean the filter, or if the spa is reporting “low water flow,” clean the screen in addition to the filter. First, remove the filter(s) as described in the Filter Cleaning section above.
Dimension One Spas - Bay Collection - Owner’s Manual Light Bulb Replacement 1. 2. 3. 4. 5. Turn the power off at the GFCI breaker and drain the water to below the level of the light. Using the special tool provided in the owner’s manual packet, unscrew the lens that covers the light housing. Remove the old bulb and install the new bulb. Use the special tool to replace the lens on the light housing. Turn the light on and off to make sure it works before refilling the spa.
Dimension One Spas - Bay Collection - Owner’s Manual Care for Envirotect™ Skirts and Vinyl Covers The Dimension One Envirotect skirts are unaffected by most corrosive substances, and will not absorb moisture. To maintain the original skirt finish, clean with soap and water. No sealing or painting is required.
Dimension One Spas - Bay Collection - Owner’s Manual Springtime Startup of a Winterized System If the spa has been Winterized, Dimension One highly recommends that you contact an authorized dealer to restart it. The following is an outline of the procedures involved. • • • • • • • • • Make sure o-rings for pumps are in place and undamaged. Make sure all the fittings that loosened are re-tightened.
Dimension One Spas - Bay Collection - Owner’s Manual Troubleshooting Guide Heating System Symptom Problem Corrective Action Does not heat 1. Temperature setting is too low 1. Turn up the thermostat 2. Dirty filter 2. Clean filter, including inner filter screen 3. Flow switch malfunction 3. Call for service 1. Temperature setting is to high 1. Turn down the thermostat 2. High limit tripped 2.
Dimension One Spas - Bay Collection - Owner’s Manual Water System Symptom Problem Corrective Action Pulsating jets Water level too low Fill with water to approximately 6 inches below the top of the spa. No Jet Action, or action is poor 1. Jets are turned off 1. Turn jets on by turning jet face clockwise 2. Diverter Valve turned 2. Turn the Diverter Valve clockwise or counter clockwise 3. Dirty Filter 3. Clean Filter, including inner filter screen 4. Air lock 4.
