Programming Tutorial

At this point, if the program was loaded into a DELight controller, channel one would
turn on above half stick, and off below half stick. Because the program repeats when it
runs out of blocks, for this example the “Time” value of the blocks does not matter.
Example two: Making a flashing LED
Next, we are going to make an LED connected to channel two flash when the input is
above 80% stick, and stay on continuously when the input is below 80% stick.
Begin by selecting the Channel 2 tab. Create one block at 100% brightness in the top
track, and one block at 100% brightness in the bottom track as shown below. This will
form the starting point.