Programming Tutorial

controlling smoke pumps, glow wire inverters or any other system which can take power
from the RX.
First, create two blocks of 0% brightness with duration of .5 seconds in the top track of
both channels 5 and 6. Create a single block of brightness 0% in the bottom tracks of both
channels. Make Channel 5 colored red, and Channel 6 colored blue. Channel 5 is shown
below.
Now, we could edit these further in their individual tabs, but for lights which need to
synch up, it is easier to work in the All Channels tab, which is shown below. Notice that
there are six channels shown. The input slider at the right controls whether the top or
bottom track of each channel is shown. Drag the slider to 100% so we can be sure we are
editing the top tracks.